First connect the “Network
cable” to the printer
Step 1: Hold finger on the “feed” button
Step 2: (Finger still holding down the feed button) Turn “on” the printer
Step 3: Wait Approximately 23 seconds wait until the red
power light and error light flashing twice and remove finger from “feed” button
Next:
Step 1: Hold finger on the “feed” button
Step 2: (Finger still holding down the feed button) Turn “on” the printer
Step 3: Wait until Printer Beeps and remove finger from “feed” button
Self-test will now print
As shown: The Self-test will print and give you
information regarding the printer. You will need the “IP Address” NOTICE:
Net DHCP will it to
say it is disabled but Ip is now fixed
Open a web browser (Only can be done on a Windows based PC. Ex: Chrome or Internet Explorer)
Type in “IP Address” from the printer and press “Enter”
As Shown: The site you will be brought to after pressing
“Enter”
Select “Fix IP Address”
Select “Save” then Select
“OK” then Select “Restart”
On this new firmware version 1.33ZRG DHCP will always be DISABLED as once you get an Ip on a network the printer Ip will be fixed.
Below is
what we need to create when adding a printer to the back office.
How to connect Bluetooth Printer:
In the POS Hardware Settings, under Printer Settings, Select “BLE”
Select “Printer001” PLEASE NOTE: Make sure ALL
Bluetooth printers are turned off before selecting “Printer 001” since ALL
Bluetooth printers say “Printer 001”